PT High Efficiency White LED Driver. FEATURES. ○ V to V Input Voltage Range. ○ 35V Maximum Step-Up Voltage. ○ <1µA Shutdown Mode. Texas Instruments PT DC DC Converters parts available at DigiKey. 30 Aug The PT is a high efficiency step-up DC/DC converter designed for driving multiple strings of up to eight series-connected white LED from a.
|Published (Last):||14 April 2009|
|PDF File Size:||4.56 Mb|
|ePub File Size:||16.59 Mb|
|Price:||Free* [*Free Regsitration Required]|
Selecting the inductor Choose an inductor that does not saturate under the worst-case load transient and startup conditions. Use a capacitor with RMS current rating greater than the inductor ripple current. Choose a diode whose maximum reverse ptt4110 rating is greater than the maximum output voltage. Dimming Control There are two different types of dimming control circuits: The LED current is controlled by the feedback resistor. The dimming control using a DC voltage.
Selecting the Output Capacitor. The LEDs operate at either zero or. Parts tamper ed with by grinding, engraving, drilling, cutting or applying coatings of any kind.
Thus, the LED current decreases. Ceramic capacitors are preferred, but tantalum or low-ESR electrolytic capacitors may also suffice. Please, log in or register. Selecting the Input Capacitor An input capacitor is required to supply the AC ripple current to the inductor, while limiting noise at the input source. The LED current is. We promise the long terms continuity supply and would never end supply. China Resources Powtech Shanghai Limited.
Evidence of damage caused by operating outside of specified temperature range.
Brand new original POWTECH LED driver IC PT4110
EastRising gives the promise to every customer to every product we sell on this web store. It regulates the output current, ideal for driving light emitting diodes LED whose light intensity is proportional to the current passing through them. Make sure that the. The typical frequency range of the PWM signal should be higher than 20 kHz to avoid the audio noise.
LED Backlight Driver IC Chip PT in SOT Package
The PT will pt110 switch at its maximum duty cycle. Using a DC Voltage. However since it absorbs the input switching current it requires an adequate ripple current rating. The output of PT is equal high level of SW pin subtracting the forward voltage of the Schottky diode.
In order to have accuracy LED current. The LEDs operate at either zero or full current. PT is equal high level of SW pin subtracting the. Low ESR capacitors are preferred to.
For most of the. The output rectifier diode supplies current to the. There are two different types of dimming control.
The rated average forward current needs. In order to have accuracy LED current, precision resistor is preferred. Its low mV feedback voltage reduces power loss and improves efficiency. The output capacitor is required to maintain the DC. Powtech PT Datasheet Preview.
Low ESR capacitors are preferred to keep the output voltage ripple to a minimum. The characteristic of the output capacitor also affects the stability of the regulation control system.
To reduce losses due to diode forward voltage and recovery time, use a Schottky diode. The PT detects the voltage of SW pin. We will, at our option, either a repair the product using new or refurbished parts, or b replace pt41100 product with a new or refurbished product.
PT 데이터시트(PDF) – Sharp Electrionic Components
Company Info About BuyDisplay. However since it absorbs the input switching current it.
The typical frequency range. PT detects the voltage of SW pin.
Stock levels are based on item’s sales history.